ASTM D5710/D5710M−15 Standard Specification for Trinidad Lake Modified Asphalt

This standard is issued under the fixed designation D5710/D5710M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.

A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval.

ASTM D5710/D5710M−15 Standard Specification for Trinidad Lake Modified Asphalt

Scope
1.1 This specification covers Trinidad Lake modified asphalt for use in the construction of pavements.

1.2 This specification covers the following penetration grades:
40–55 60–75 80–100 120–150

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5710/D5710M−15 Standard Specification for Trinidad Lake Modified Asphalt

Properties
4.1 The blended Trinidad Lake modified asphalt shall be homogeneous as determined by appropriate sampling and testing.