ASTM D2026/D2026M−15 Standard Specification for Cutback Asphalt Slow-Curing Type

This standard is issued under the fixed designation D2026/D2026M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.

A number in parentheses indicates the year of last reapproval.

A superscript epsilon (´) indicates an editorial change since the last revision or reapproval.
This standard has been approved for use by agencies of the U.S. Department of Defense.

ASTM D2026/D2026M−15 Standard Specification for Cutback Asphalt Slow-Curing Type

Scope
1.1 This specification covers cutback petroleum asphalts of the slow-curing type for use in the construction and treatment of pavements.
1.2 Units—The values stated in either SI units or inch pound units are to be regarded separately as standard.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

Combining values from the two systems may result in nonconformance with the standard.

ASTM D2026/D2026M−15 Standard Specification for Cutback Asphalt Slow-Curing Type

Properties
3.1 The cutback asphalt shall not foam when heated to application temperature and shall conform to the requirements prescribed in Table 1.

This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years and if not revised, either reapproved or withdrawn.