ASTM C1107/C1107M − 14a Standard Specification for Packaged Dry Hydraulic-Cement Grout Nonshrink

ASTM C1107/C1107M − 14a Standard Specification for Packaged Dry Hydraulic-Cement Grout Nonshrink

Scope
1.1 This specification covers packaged dry, hydraulic cement grout (nonshrink) intended for use under applied load (such as to support a structure, a machine, and the like) where a change in height below initial placement height is to be avoided.

1.2 Grouts covered are composed of hydraulic cement, fine aggregate, and other ingredients. They require only the addition of mixing water for use.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

Combining values from the two systems may result in non-conformance with the standard

ASTM C1107/C1107M − 14a Standard Specification for Packaged Dry Hydraulic-Cement Grout Nonshrink

Ordering Information

4.1 When the purchaser specifies that properties of the packaged, dry grout meet the requirements of this specification, also specify which, if any, of the optional requirements apply.

4.2 When the grout is to be used in contact with stressed tendons or other corrosion-sensitive, load-bearing structural members, the purchaser shall supply this information to the manufacturer and obtain assurances that the material meets relevant chloride, nitrite, nitrate, sulfide, and sulfate requirements, and any other material limitations imposed by the applicable codes and standards (see Note 1).